The forward and reverse rotation of the rolling shutter door motor needs to be achieved through wiring. Firstly, disconnect the power supply and check the wiring ports of the motor, which usually have corresponding markings. Refer to the motor manual to determine which wires control forward rotation and which control reverse rotation. Note that the wiring method may vary slightly for different brands and models of motors. After the wiring is completed, connect the power supply and test whether the motor's direction of operation meets expectations.
If the direction of motor operation is opposite to the expected direction, the forward and reverse directions can be switched by swapping the positions of any two opposite wires. For example, swap the position of the blue wire with the yellow wire. It should be noted that the power supply must be disconnected before adjustment to avoid electric shock accidents.
